New Forum area as of April 3, 2010: Unfortunately this means all previous users will need to re-register as the database has been wiped!

Stray Technologies Forums » Bliptronome Kit

Issues with ADC 0 and 1

(4 posts)

  1. Rick
    Member

    Hi Will.
    First thanks a lot for sharing all the information regarding this project.
    I put together one of these units using a spare duemilanove i had hanging around. It works flawlessly with the exception of reading the values from the pots connected to the first two ADC inputs (0 and 1).
    I have no hardware problems (I tested another firmware on my board and could read all the ADC inputs) and arduinome serial has them enabled.
    Any ideas about this? Is it something in your firmware that has them disabled? Just wanted to ask before diving into it.
    Thanks again
    best
    r

    Posted 1 year ago #

  2. Wil
    Key Master

    Hey Rik,
    The ADC's need to be turned on by a command from the host software (ex: the check boxes in ArduinomeSerial should do this).This is part of the original protocol, so I followed suite in the Bliptrnome version.

    Posted 1 year ago #

  3. Rick
    Member

    Hi Will..
    yup.. I've done that, all the the checkboxes in arduinome serial are checked (except the encoders, though I also tried enabling them just in case).. that's why I was wondering if there was something else related to the firmware
    Anywho, thanks for your answer and all your work. I'll keep digging and let you know if I find something. I have several of this boards around I can test, maybe it is Mr Murphy messing around.
    best
    r

    Posted 1 year ago #

  4. Rick
    Member

    Hi Will...
    Just wanted to update (and give an end to) this thread.
    The problem I was having was with the Duemilanove board. It seems that it was half fried and ended up dying some moments ago. I switched boards and it worked flawlessly, then while retesting the first one it went dead. Apparently I abused a bit too much a while back ;)
    I just finished implementing an mlr clone in pd and looking to use the pots for some added features.
    Thanks again
    r

    Posted 1 year ago #

RSS feed for this topic

Reply

You must log in to post.